These are screenshots of my first attempt at lofting my initials in Fusion 360. The overall shape achieved was elegant however I was only able to make my model 0.05mm thick. This is due to the ten edges coming off the right side of the letter 'E' all converging into a flat surface causing them to intersect.
Model of ideal room (1:20 scale)
- Cardboard and black spray paint
When taking these photographs I was trying to focus on the shadow produced by the window as well as the sections highlighted on the window sill. I achieved this by painting the model all black and using a torch to achieve a directional light source when taking the pictures. By using a white sheet of paper as a backdrop I was able to get rid of any sort of ridge line.
- Cardboard and black spray paint
When taking these photographs I was trying to focus on the shadow produced by the window as well as the sections highlighted on the window sill. I achieved this by painting the model all black and using a torch to achieve a directional light source when taking the pictures. By using a white sheet of paper as a backdrop I was able to get rid of any sort of ridge line.
No comments:
Post a Comment